This PRP® Trigger Kit is compatible with the Ruger® LC9S®, LC9S Pro® and EC9S® models.* It includes our sear and trigger pivot. They are CNC machined out of heat treated 440c stainless steel and have our proprietary geometry. When properly installed they will slightly reduce the take up and greatly reduce the over travel and give you a quicker reset. It will also lower your trigger pull to about 3.5lbs. These parts should Drop-In with only minor fitting to the trigger pivot for pre-travel, reset, and over-travel. The sear may need to be fit for the thumb safety engagement.
*Ruger® and 10/22® are registered trademarks of Sturm, Ruger & Co., Inc. Powder River Precision® (PRP®) and its products are not affiliated with or associated with Ruger®.
⚠️WARNING: This product can expose you to chemicals including lead, which is known to the state of CA to cause cancer, birth defects or other reproductive harm. www.P65Warnings.ca.gov
Review migrated from original PRP website –
Hits the sweet spot on the LC9s Pro
LC9s Pro, install took an hour. You don’t need to remove the trigger safety. Instead, just use a pen magnet and stick it on top of the trigger pin head, then push in on trigger spring and the pin pull right out. Kit installs easily. I did have to adjust the over travel, but the directions were clear and the fitting easy with a file. Take up was reduced by 0.07 inches; over travel reduced by 0.17, and the reset point changed by 0.03. Trigger pull was noticeably reduced, but I don’t have a gauge. Overall, it was a very nice improvement. If you just carry your gun for self-defense, then just stick with the already good factory trigger, but if you actually shoot the gun on a regular basis, this hits the sweet spot. I find it surprisingly similar in feel to my XDM with the PRP Extreme Trigger Kit. Not as short on the pull or reset, but a similar feel. Nice job PRP!